Transistor/IC Regulated Power Supplies |
Eletronically Regulated Power Supply:
(ZES-200)
|
| Input |
230volts AC |
| Output |
0-300volts DC at 200 mA continuously variable. |
| Bias |
0-150 volts DC at 5 mA continuously variable. |
| L.T. |
6.3 volts at 3 Amps |
| Regulation |
±1% |
| Controls |
Power on/off H.T. control, bias control output terminals and jewel
Light are located on front panel. The unit is enclosed in a steel
Cabinet Using two round meters. |
|
(ZES-201)
|
| Input |
230volts AC 50c/s |
| Output H.T. |
0-300volts 100mA continuously variable and metered for H.T.
volt and mA. |
| Bias |
0-30volts DC at 5mA continuously variable. |
| L.T. |
6.3volts at 3Amps |
| Regulation |
± 1% |
| Controls |
Power on/off H.T. control, bias control output terminals and jewel
Light are located on front panel. The unit is enclosed in a steel
Cabinet Using two round meters. |
|
(ZES-202)
|
| Input |
230volts AC 50c/s |
| Output H.T. |
0-300volts DC at 50mA |
| Bias |
0-30volts at 10mA |
| L.T. |
6.3volts at 3Amps. |
| Regulation |
±1% |
| Stabilization |
Better than 1% for a variation of 10% AC mains supply. |
| Ripple Content |
Approximately 10 Milli Volts. |
| Power Requirements |
230volts AC 50c/s |
|
| |
Electrically Regulated Power Supply:
(ZES-203)
For Triode Experiment, with three round meters |
| |
Electrically Regulated Power Supply :
(ZES-204)
For Diode Experiment, with Two round meters. |
| |
Electrophoresis Power Supply :
(ZES-205)
(a) — do – 300V/100mA with 2 Analog meter
(b) ---do— 300V/100mA with digital meter.
(c) ---do— 300V/50mA with 2 analog meter.
(d) ---do— 300V/50mA with digital meter. |
| |
